Before You Begin
Before you begin installing your system in the rack, carefully read “Safety Instruc- tions,” found earlier in this guide.
NOTICE: This rack kit is intended to be installed in a Dell rack by trained service technicians. If you install the kit in any other rack, be sure that the rack meets the specifications of American National Standards Institute (ANSI)/Electronic Industries Association (EIA) standard
Recommended Tools and Supplies
You need the following tools and supplies to install the system in a
•
•
•
A #2 Phillips screwdriver
A
Masking tape or a
Installing the Rack Kit
NOTES: If you purchased a Dell rack along with your system, the slide assemblies may be preinstalled in the rack.
For instructions on installing the system itself, see “Installing the System in the Four- Post Rack” found later in this guide.
To install the slide assemblies in the rack, perform the following steps:
1.Remove the rack’s front and back doors.
2.Install the slide assemblies in the rack.
The subsections that follow include instructions for performing these tasks.
support.dell.com | Rack Installation Guide |