Dell 100 14.Removing the 24-URack Doors, hinge pin hinge insert hinge, Rack Installation Guide

3.Remove the front door from the rack as shown in Figure 1-14.

a.With the door open, lift out and fully retract all hinge pins.

b.Once all the hinge pins have been lifted out and retracted, lift the door out.

hinge pin

hinge insert

hinge

Figure 1-14. Removing the 24-U Rack Doors

CAUTION: Store the two doors where they will not injure someone if the doors accidently fall over.

If you want to reverse the door so that the handle is on the other side, perform the following steps:

1.With the door open, lift out and fully retract all hinge pins.

2.Remove the hinges and door brackets from the door frame.

3.Replace the hinges and door brackets on the opposite side and switch the posi- tion of the handle.

4.Replace the rack door (see the section, “Replacing the Rack Doors,” found later in this guide).

Installing the Slide Assemblies in the Four-Post Rack

NOTE: If the slide assemblies were preinstalled by Dell, you can skip this section.

support.dell.com Rack Installation Guide 1-17