To install the slide assemblies in the rack, perform the following steps:
1.Place the front of the template on the vertical rails at the front of the rack where you want to install the system.
2.Ensure that the printing on the template identifies the side facing outwards as the template front.
3.Position the bottom of the template in line with the desired bottom position of the system chassis.
4.Mark the rack’s front vertical rails with a
5.Make a mark or place tape on the vertical rails next to the template’s
1 U (1.75 inches) between slide assemblies (drawing is not to scale)
Figure 1-16. Using Template to Mark Vertical Rails
support.dell.com | Rack Installation Guide |