Dell 350, 110, 100 manual Attaching the Brackets, Installing the System in the Rack

Attaching the Brackets

1.Locate one of the two brackets and align it over the two threaded holes on the side of the system (see Figure 1-3).

2.Secure the bracket to the system chassis using two 10-24 x 0.375-inch screws (see Figure 1-3).

Repeat this step to install the remaining bracket on the other side of the system.

12-24 x 0.5-inch pan-head Phillips screws

10-24 x 0.375-inch pan-head Phillips screws (2 per bracket)

Figure 1-3. Securing the System in the Rack

Installing the System in the Rack

CAUTION: Due to the size and weight of the system, never attempt to install the system by yourself.

1.Lift the system into position between the two posts, with the hole in the mount- ing bracket aligned one hole above the mark you made in the two posts.

2.Secure the system to the rack using a 12-24 x 0.5-inch screw through the mount- ing bracket to the front of the left and right posts (see Figure 1-3).

3.Attach the front bezel, if it is not already attached, to the system (see the Installation and Troubleshooting Guide for instructions).

This completes the two-post center-mount rack installation.

1-4 Rack Installation Guide