Adding Parts 73
7To remove the card, grasp the card by the top corners and lift it out.
HINT: The AGP card is
removed from the
following illustration to
provide a better view of
the inside of your
computer.
If the card is difficult to remove, gently ease the card back and forth to
remove it from the connector.
HINT: Installing filler
brackets over empty card-
slot openings is necessary
to maintain Federal
Communications
Commission (FCC)
certification of the
computer. The brackets
also keep dust and dirt out
of your computer.
8If you are not replacing the card, install a filler bracket in the empty
card-slot opening.
If you are adding a card, see page69.
9Lower the securing lever.
10 Close the computer cover (see page87).
11 Connect your computer and devices to their electrical outlets, and
turn them on.
NOTICE: To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
card
securing lever slot connector
system board
filler bracket in empty
card-slot opening
back of computer