84 Adding Parts
www.dell.com | support.dell.com
12 Connect your computer and devices to their electrical outlets, and
turn them on.
NOTICE: To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
13 See the documentation that came with the drive for instructions on
installing any software required for drive operation.
3.5-Inch Devices CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in "When Working Inside Your
Computer" on page 12.
1Shut down the computer (see page20).
2Turn off any attached devices and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
3Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
4Unpack the drive and prepare it for installation.
See the documentation that came with the drive to ensure that the
drive is setup for your computer.
5Open the computer cover (see page65).
6To remove the front panel insert, carefully press the panel out from the
inside of the computer.