Removing The Front Thermal Sensor | Dell 4691901 specs

Removing The Front Thermal Sensor

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the cover.

3.Remove the front bezel.

4.Disconnect the thermal-sensor cable from the system board.

5.Unthread the thermal-sensor cable from the chassis clips.

6.Unthread the thermal-sensor cable from the chassis clip.

7.Pry the thermal sensor away from the chassis front and remove.

23

Image 23

Dell 4691901 owner manual Removing The Front Thermal Sensor

Contents

Regulatory Model D07D Regulatory Type D07D001 Dell Inc Contents Troubleshooting System Setup Contacting Dell SpecificationsPage Before Working Inside Your Computer Working on Your Computer After Working Inside Your Computer Turning Off Your Computer Related Links Installing The CoverRemoving the Cover Removing the Expansion Card Installing The Front BezelRemoving the Front Bezel Page Removing the Optical Drive Installing The Expansion Card Removing the Hard Drive Installing The Optical DrivePage Removing the Memory Installing The Hard Drive Removing the Chassis Intrusion Switch Installing The Memory Removing The Speaker Installing The Chassis Intrusion Switch Installing The Speaker Removing The Heat Sink and Processor Installing The Heat Sink and Processor Removing The Power-Switch Cable Removing The Coin-Cell BatteryInstalling The Coin-Cell Battery Installing The Power-Switch Cable Removing The Front Thermal Sensor Removing The System Fan Installing The Front Thermal Sensor Installing The System Fan Removing The Input/Output Panel Installing The System Fan Remove the Input/Output panel Installing The Input/Output PanelRemoving The Power Supply Disconnect the 4-pin power cable from the system boardPage Installing The Power Supply Remove the expansion cards Removing the System Board Remove the system board from the chassis Installing the System BoardRemoving The PSU Thermal Sensor Installing The PSU Thermal Sensor CtrlAltF8 One-time boot and diagnostics utility menu F12 System SetupBoot Menu Boot Menu Enhancements Action Keystroke Beep Codes and Text Error MessagesTiming Key Sequences Navigation System Setup Options Security Password Changes Password BypassPassword prompts during a system restart They are set. This option is disabled by default Performance Power Management Virtualization Support Enable F12 Boot menu enabled by defaultMaintenance Post Behavior System Logs Power Button Diagnostic LEDsDiagnostic Light Patterns Troubleshooting Steps Possible system board failure has occurred Re-seat the 2x2 power connector from the power supply unitPower Button Problem Description If the problem persists, the system board is faulty Reinstalled all modules without error Problem Description Troubleshooting Steps Code Cause Microprocessor register failure Beep Codes Code Cause Code Cause DMA initialization failureCode Through Cause Code Cause Time-of-day clock stopped Error MessagesAddress mark not found Code Cause No time tick Shutdown failure Gate A20 failure Data error Alert! Security override Jumper is installedBad command or file name Bad error-correction code ECC on disk read Diskette read failure Diskette subsystem reset failedHard-disk drive configuration error Diskette drive 0 seek failure Keyboard failure Invalid configuration information-please run Setup programInvalid Memory configuration, please populate DIMM1 Memory allocation error Non-system disk or disk error No boot device availableNo boot sector on hard-disk drive No timer tick interrupt Time-of-day not set-please run the System Setup program Read faultReset failed Seek error \ is not accessible. The device is not ready Unexpected interrupt in protected modeWrite fault Write fault on selected drive Memory SpecificationSystem Information Processor Cards AudioNetwork Expansion Bus Audio Back Panel Mini-Tower/Desktop External ConnectorsSystem Board Connectors Mini-Tower Two Desktop One Small Form Factor Controls and Lights Environmental Physical Height Width Depth WeightPage Visit support.dell.com Contacting Dell