4-16 Del l Preci si on 610 Mini Tower Systems Service Manual
,QWHUQDO'ULYH$VVHPEOLHVLQWKH+DUG'LVN'ULYH%UDFNHW
To remove the hard-disk drive bracket, follow these steps:
If any hard-disk drives are already installed in the bracket, disconnect the
DC power cable and interface cable from each drive.
Grasp the handle of the drive cage door on the front of the c hassis, and p ull
out and down until the arms on the drive cage door (see Figure 4-1 3) di sen -
gage from the tabs on the bracket. This action pulls the bracket out of the
drive cage about 1 to 3 inches.
When removing the bracket from the drive cage, you should remove it
slowly and cautiously, using two hands to support the weight of the
bracket. The bracket can be quite heavy, especially if it is populated with
drives.
tabs on bracket (2)
drive cage
arms on drive
cage door (2)
drive cage door