8.Remove the two shorter, green plastic rails from the inside of the computer cover.
These rails are not attached to the computer cover with screws. To remove the rails, firmly pull the rails from the drive cage.
9.Attach the rails to the drive using the screws supplied with the drive.
Ensure that the rail tabs are positioned at the back of the drive.
10.Gently slide the drive into the bay until you hear a click.
11.Carefully replace the drive bay cover.
You do not need to replace the cover insert.
12.Connect a power cable to the drive.
See the documentation that came with the drive for instructions on connecting a drive cable to the drive.
HINT: Your computer uses
13.Close the computer cover.
14.Connect your computer and devices to their electrical outlets, and turn them on.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
15.Install any drivers required for the drive as described in the documentation that came with the drive.
Replacing the Microprocessor
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in "Safety Instructions."
1.Shut down the computer.
2.Turn off any attached devices and disconnect them from their electrical outlets.
