CMOS
Checksum
Failure
CMOS System
Options Not
Set
CMOS Display
Type
Mismatch
CMOS Memory
Size
Mismatch
CMOS Time
and Date Not
Set
Diskette
Boot Failure
DMA Error
DMA 1 Error
DMA 2 Error
FDD
Controller
Failure
HDD
Controller
Failure
INTR1 Error
INTR2 Error
Invalid Boot
Diskette
Keyboard
Error
KB/Interface Error
No ROM
Basic
program is incorrect or the battery charge may be low.
Drive A or B is present but has failed the BIOS POST.
Error in the DMA controller on the system board.
The BIOS cannot communicate with the floppy drive or hard drive controller.
An interrupt channel on the system board failed to POST.
The operating system cannot be located on drive A or drive C.
The BIOS has detected a stuck key.
An error occurred with the keyboard connector.
The operating system cannot be located on drive A or drive C.
computer.
Ensure that the drive is installed correctly in the computer and defined correctly in the system setup program. Check the interface cable at both ends.
The keyboard or system board may need to be replaced.
Ensure that the drive is installed correctly in the computer and defined correctly in the system setup program. Check the interface cable at both ends.
The keyboard or system board may need to be replaced.
Enter the system setup program and confirm that drive A or drive C is properly identified.
Ensure that nothing is resting on the keyboard; if a key appears to be stuck, carefully pry it up. If the problem persists, you may need to replace the keyboard.
Ensure that nothing is resting on the keyboard; if a key appears to be stuck, carefully pry it up. If the problem persists, you may need to replace the keyboard.
Enter the system setup program and confirm that drive A or drive C is properly identified.
