Dell KH934 owner manual Diskette Drive, Replacing an Insert on the Front Drive Bezel

Replacing an Insert on the Front Drive Bezel

If you remove a drive in the 3.5-inch or 5.25-inch drive bays, replace the corresponding insert on the front drive bezel. From the back of the bezel, fit the tab on the end of the insert into the notch on the bezel and snap the other end of the insert into place. See Figure 3-4.

Figure 3-4. Removing and Replacing the Front Drive Bezel Insert

1

2

4

3

1 front drive bezel 2 insert tabs 3 drive bezel insert

4screws for an optional 5.25-inch drive (3)

Diskette Drive

The 3.5-inch drive bay supports an optional standard diskette drive.

Removing the Diskette Drive

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.

1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 41.

3Remove the front drive bezel. See "Removing the Front Drive Bezel" on page 42.

4Disconnect the power and data cables from the diskette drive. See Figure 3-5.

5Slide the lever on the sliding plate in the direction of the arrow. See Figure 3-5.

6Hold the lever in position and slowly pull the drive out of the bay.

44

Installing System Components