To replace the palmrest assembly, perform the following steps:
1.Place the palmrest assembly on the bottom assembly.
2.Reinstall the three silver M2 x
3.Reinstall the four black M2 x
4.Connect the touch pad flex cable to the ZIF connector on the system board.
5.Connect the status lights flex cable to the ZIF connector on the system board.
6.Turn the computer upside down.
7.Reinstall the six M2.6 x
8.Turn the computer
9.Reinstall the keyboard assembly.
10.Reinstall the display assembly.
11.Reinstall the keyboard bezel.
Touch Pad Assembly
M2 x
touch pad holder assembly
touch pad
ZIF connector | flex cable |
|
Figure 16. Touch Pad Removal
NOTICE: To avoid damaging the system board, you must remove the main battery before you service the computer.
1. Remove the keyboard bezel.
support.dell.com | Dell Latitude L400 Service Manual | 21 |