ZIF Connectors
Some of the computer’s interface connectors are zero insertion force (ZIF) connectors. These connectors are not removable, but they must be released to disconnect a cable from them (see Figure 4).
movable part of connector
(do not remove)
Figure 4. Disconnecting an Interface Cable
NOTICE: The ZIF connectors are fragile. To avoid damage, do not apply too much pressure to the movable part of the connector.
To disconnect an interface cable from a ZIF connector, perform the following steps:
1.Insert a small
2.Pull gently upward on the movable part of the connector until it releases the interface cable.
3.Grasp the interface cable and pull it out of the connector.
To reconnect an interface cable to a ZIF connector, perform the following steps:
1.Use a small
2.Orient the end of the interface cable with the ZIF connector, and insert the end of the cable into the connector.
3.While holding the cable in place, close the ZIF connector.
To ensure a firm connection, make sure the ZIF connector is completely closed.
support.dell.com | Dell Latitude L400 Service Manual | 5 |