Installing the RF Holder
1.Place the RF holder on the computer.
2.Tighten the screws that secure the RF holder to the computer.
3.Connect the antenna cable.
4.Route the antenna cable.
5.Install:
a.WLAN Card
b.WWAN Card
c.Bottom Cover
d.Optical Drive
e.Hard Drive
f.Battery
6.Follow the procedures in After Working Inside Your computer
Removing the Display Assembly
1.Follow the procedures in Before Working Inside Your Computer
2.Remove:
a.Battery
b.Hard Drive
c.Optical Drive
d.Bottom Cover
3.Perform the following steps as shown in the illustration:
a.Lift the locking tab [1].
b.Disconnect the I/O cable [2].
c.Peel the adhesive tape [3].
d.Disconnect the eDP cable on the system board [4].
e.Peel the adhesive tape [5]
f.Disconnect the display assembly cable on the system board [6]
23
