Dell T410 owner manual System Messages

•Clear the SEL — You can perform this task remotely, but you will lose the event history for the system.

•Power cycle — Turn off the system and disconnect it from the electrical outlet; wait approximately ten seconds, reconnect the power cable, and restart the system.

Any of these actions will remove fault messages, and return the status indicators and LCD colors to the normal state. Messages will reappear under the following conditions:

•The sensor returns to a normal state but fails again, resulting in a new SEL entry.

•The system is reset and new error events are detected.

•A failure is recorded from another source that maps to the same display entry.

System Messages

System messages appear on the screen to notify you of a possible problem with the system.

NOTE: If you receive a system message not listed in the table, check the documentation for the application that is running when the message appears or the operating system's documentation for an explanation of the message and recommended action.

Table 1-3. System Messages

Message	Causes	Corrective Actions
128-bit Advanced	The Advanced ECC option	Check other messages for a
ECC mode	enabled in BIOS is no longer	faulty memory module.
disabled. For	valid due to an unsupported	Reconfigure the memory
128-bit Advanced	memory configuration,	modules for Advanced ECC
ECC, DIMMs must	possibly a faulty or removed	mode. See "System Memory"
be installed in	memory module. The	on page 106.
pairs. Pairs must	Advanced ECC setting has
be matched in	been disabled.
size and
geometry.

42

About Your System