Replacing the Solid-State Drive | 23
Replacing the Solid-State Drive
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before Working Inside
Your Computer" on page 7. After working inside your computer, follow the
instructions in "After Working Inside Your Computer" on page 9.
For more safety best practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
1Align the notch on the solid-state drive with the tab in the solid-state drive
connector.
CAUTION: Use firm and even pressure to slide the solid-state drive into place.
If you use excessive force, you may damage the connector.
2Slide the solid-state drive at an angle into the solid-state drive connector.
3Press down the other end of the solid-state drive and replace the screw that
secures the solid-state drive to the system board.
4Adhere the tape over the solid-state drive.
Postrequisites
1Replace the battery. See "Replacing the Battery" on page 15.
2Connect the power-light board cable to the system board. See "Replacing the
Power-Light Board" on page 13.
3Replace the base cover. See "Replacing the Base Cover" on page 11.