
2Remove the existing modem:
a Remove the modem cable from the RJ11 internal connector.
b Use a small Phillips screwdriver to remove the two screws securing the modem to the system board, and set the screws aside.
c Pull straight up on the attached
d Remove the modem cable from the modem.
3Install the new modem:
a Replace the
b Align the modem with the screw holes and press the modem into its connector on the system board.
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and realign the card.
cUse a Phillips screwdriver to replace and tighten the two screws that secure the modem to the system board.
dReplace the other end of the modem cable to the RJ11 internal connector.
4Replace the computer cover (see "Replacing the Computer Cover" on page 96).
Battery
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
A
CAUTION: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer’s instructions.
Replacing the Battery
NOTE: For information regarding the type of
1Record all the screens in system setup (see "System Setup" on page 101) so that you can restore the correct settings in step 9.
2Follow the procedures in "Before You Begin" on page 61.
94