Delta Temperature Controller User Manual
| Display | |
PV |
| SV |
Press for more than 3 seconds to enter initial setting mode
Back to top
Explanations
Status of the temperature controller
Message displayed when DTA has not yet been connected to a sensor.
Select the sensor connected. Default = PT100
Temperature unit. Default = °C
Upper limit of temperature range
Lower limit of temperature range
The control modes include: PID, ON/OFF, MANUAL. Default = PID. Select “ON/OFF” here.
Select heating or cooling mode. Default = heating
Set up Alarm mode 1. Default = alarm output disabled
Set up Alarm mode 2. Default = alarm output disabled
ON/OFF of communication
Communication address
Communication speed
Data length (in bits)
Parity bit
Stop bit
- 12 - | © DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED |