Delta Electronics DTC1000R How to Return to Default Settings in DTC, DTCOM Software, Explanations

	Delta Temperature Controller User Manual
DTCOM Software	Explanations
	Clear the user’s settings.
	Function address = 474E; Write data = 1234
	(Please DO NOT modify this value; otherwise
	system confusion may occur.)
	After the above procedures are completed, DTB
	will display the information on the left hand side,
	representing that DTB has return to default
	settings successfully.
Switch off DTB and re-power it.
	Return to default value. The default sensor is
	PT100, which will be displayed when DTC is not
	connected to a sensor or thermocouple.

The model adopted in this example is: DTB4896RR with firmware V1.50.

1.4 How to Return to Default Settings in DTC

1.Make sure RS-485 hardware communication cable in DTC has been connected to the computer.

2.Make sure the communication parameters in DTC are consistent with those in the computer.

DTCOM Software	Explanations
	Execute DTCOM Software
	Select “SINGLE COMMAND TEST”

2007-09-17 - 10 - © DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED