Delta Electronics DTA4896R1, DTC1000R Control Modes In Dtc, 4.1 ON/OFF, Display, Explanations

Delta Temperature Controller User Manual

	Display
PV		SV

Explanations

Status of the temperature controller

Set up the position of decimal point

Key-locked function

Output volume. In PID PROG control mode, this is a read-only parameter and cannot be modified.

CHAPTER 4: CONTROL MODES IN DTC

4.1 ON/OFF

There are four control modes in DTC: ON/OFF, MANUAL, PID and PID PROG. Due to that DTC has no display panel, the settings and monitoring of parameters have to rely on communication. Therefore, you have to check the following 2 items to ensure normal communication.

1.Make sure RS-485 hardware communication cable in DTC has been connected to the computer.

2.Make sure the communication parameters in DTC are consistent with those in the computer.

Next, open DTCOM Software and switch to ON/OFF control mode.

© DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED - 21 - 2007-09-17