Delta Electronics Series E36SR manual Electrical Characteristics Curves

Models: Series E36SR

1 15

Page 6

ELECTRICAL CHARACTERISTICS CURVES

Vo(+)

Vo(-)

Figure 12: Input reflected ripple current, is, through a 12µH	Figure 13: Output voltage noise and ripple measurement test
source inductor at 48Vin and 15A output current (20 mA/div,	setup.
2us/div).

Figure 14: Output voltage ripple at 48Vin and rated load current (Io=15A)(20 mV/div, 2us/div)

Load capacitance: 1µF ceramic capacitor and 10µF tantalum

capacitor. Bandwidth: 20 MHz.

Figure 15: Output voltage vs. load current showing typical current limit curves and converter shutdown points.

DS_E36SR05015_01042008

Image 6

Contents

FEATURES DC/DC Power Modules 18~75V in, 5V/15A outDelphi Series E36SR, 75W Eighth Brick Family OPTIONSOUTPUT CHARACTERISTICS TECHNICAL SPECIFICATIONSINPUT CHARACTERISTICS DYNAMIC CHARACTERISTICSELECTRICAL CHARACTERISTICS CURVES ELECTRICAL CHARACTERISTICS CURVES Figure 4 Turn-on transient at full rated load current CC modeELECTRICAL CHARACTERISTICS CURVES current 25%-50% of Io, max di/dt = 0.1A/µs. Load cap 10µFtantalum capacitor and 1µF ceramic capacitor. Top Trace Vout ELECTRICAL CHARACTERISTICS CURVES Figure 12 Input reflected ripple current, is, through a 12µHDESIGN CONSIDERATIONS Safety ConsiderationsSoldering and Cleaning Considerations Input Source ImpedanceOver-Current Protection FEATURES DESCRIPTIONSOver-Temperature Protection Over-Voltage ProtectionRtrim − down = 511Δ − 10.2KΩ FEATURES DESCRIPTIONS CONOutput Voltage Adjustment TRIM Rtrim − up =THERMAL CURVES Thermal Testing SetupTHERMAL CONSIDERATIONS Thermal DeratingPICK AND PLACE LOCATION RECOMMENDED PAD LAYOUT SMDSURFACE-MOUNT TAPE & REEL Temp LEADED Sn/Pb PROCESS RECOMMEND TEMP. PROFILELEAD FREE SAC PROCESS RECOMMEND TEMP. PROFILE TimeThrough-hole module MECHANICAL DRAWINGSurface-mount module NameMECHANICAL DRAWING WITH HEATSPREADER THROUGH-HOLE MODULEWARRANTY PART NUMBERING SYSTEMMODEL LIST MODEL NAME