After some minutes of inactivity, the Workabout screen will automatically blank itself to save power. Press On/Esc once more to restore the screen display.
♦Now connect the SunScan probe to the RS232 port at the top of the Workabout. Leave the BFS sensor disconnected.
♦Press the yellow arrow keys to select the SunData icon.(A black background appears round the selected icon label.)
♦Press the yellow Enter button. (Enter always accepts the selected item.)
The SunData opening screen should appear, with a heading indicating that a probe is connected.
♦Press the red button on the SunScan probe handle once or twice.
The Workabout screen should change.
If it does, Step 2 is satisfactory.
If you cannot get this step to work, you will have another chance to test the SunScan probe after you have installed the SunData s/w in your PC.
Step 3 - Switching off the Workabout
♦Press ∪ +X to exit the SunData program.
♦Press Off.
The screen will go blank.
Checking the Workabout hardware
You should now refer the Psion Workabout User Guide chapters 1 and 2 and start familiarising yourself with the basic operation of the Psion (you will need to do this more thoroughly when you reach the tutorial sections).
The Internal drawer
The Workabout hardware installed at despatch is listed below. You can check this by pressing the drawer release button at the top left corner of the Workabout to open the battery drawer. Check for:
a)Lithium backup cell installed.
b)One
c)Flashcard in internal drive slot A
The Psion Charger
This provides power to run the Workabout, and at the same time
♦Mount the Workabout into its Docking Unit, and connect the charger to it. The indicator on the front of the Workabout will light up.
Spare
This completes the initial checks to show that the SunScan probe and Workabout are functioning. Now you must install the SunData s/w in your PC.
SunScan User Manual v 1.05 | Getting Started • 9 |