![](/images/new-backgrounds/1033980/3398023x1.webp)
Quad Amp Hardware Reference Manual
Accessories | Item | Description | Note | |
Circuit Breaker | 50 Amps 450 VAC 3 Phase | With external trip | ||
Circuit Breaker | 70 Amps 250 VAC 3 Phase | NA | ||
PWM Input Cables | 36” long cable with DB36 pin mini | Two required per | ||
|
|
| connectors at each end | Connects between Quad |
|
|
|
| Amplifier and |
External Shunt Resistor | 4.25 Ohms 1400 Watts each. | Two required for 208/230 Quad | ||
|
|
| 25” long 2” diameter | Amplifier. Three required for |
|
|
| Open Frame | 380/460 Quad Amplifier. |
|
|
|
| Connected in series. |
ACC8F | Interface Circuit Board | Two required per Quad | ||
|
|
| Used to connect Encoders to PMAC. | Amplifier. Not required if |
|
|
|
| PWM MACRO station is used. |
* | When 30 HP is | selected, only two additional | axes may be used (three total, not four). |
|
** | When a total of 7.5 HP or greater is selected, use |
| ||
*** | 600V/1200V indicates VDC rating of the igbt and has no connection to the main AC input (operating) voltage. |
8 | Introduction |