ENCAPSULATING WITH FLEXIBLE FILM POUCHES
Refer to the instruction sheet packed with each box for specific information on encap- sulating Flexible Film Pouches.
In addition, refer to the instruction sheet for information on Compatible Media, Process Conditions and technical information.
The Flexible Pouch consists of two pieces of film that are hinged at one end, along a short side. Separate the two pieces starting at the end opposite the hinge. Take care not to break the hinged seal.
1.Insert the article to be laminated in the pouch so there is at least a 1/8" (3.5mm) board around each of the sides. This ensures that moisture never reaches the image.
2.Place the pouch with the image on the sled included with the Flexible Pouches or Purchase Sleds separately.
Note: The Sled is a
3.Smooth out any wrinkles with the side of your hand or a soft flexible squeegee.
4.Tape the leading edge of the pouch to the sled using masking tape.
5. Adjust the Control Knob to the
3/16" (5mm) setting for the Sled included with your Dealers Flexible Pouches. (Or set the thickness to the thickness of the non- stick sled material you are using.)
6.Ensure that the PHOENIX rollers are turned on and set either at the ‘Rabbit’ or ‘Turtle’ speed. Turn the Heat is on, set at the ‘Pouch’ setting and wait for the LED light is Yellow indicating the roll temperature is ready to use.
Note: If your laminate appears cloudy or your print is not fully adhered to the board, adjust the speed to the ’Turtle’ setting and reprocess your pouch board.
7.Slowly insert the sled with the Flexible Pouch on top into the inlet opening.
8.Ensure that the sled is centered and straight. A gentle push may be required to start the sled into the laminator.
9.Hold the edge of the sled until it is en- gaged, and the laminator begins pulling it on its own.
10.The sled should feed through the lami- nator and automatically exit at the rear of the laminator.
CAUTION! The Sled will be hot! Allow it to lie flat and cool before removing the tape.
If there is any dirt or adhesive on the sur- face of the board, it can be removed by dampening a lint free cloth with Isopropyl Alcohol (IPA) and wiping the surface.
CAUTION! Always use care when using Isopropyl Alcohol (IPA)! IPA is very flamma- ble. The flash point of IPA is 11(51.8).The
