Figure 3
Location of Control Panel
Figure 2
O
PERATIONAL
CONTROL
P
ANEL
The Control Panel (see Figure 3) is lo-
cated on the top right of the machine. A
diagram of the Control Panel is shown
in Figure 2.
Speed Control
The speed of the rollers is controlled in
the SPEED section of the Control Panel.
1. To turn the rollers on, press the
‘On/Off’ pad once. The Green LED
light will turn on indicating the bot-
tom roller is turning. Note: the top
roller is free spinning as with all high
quality laminators. The PHOENIX will
automatically be set to the faster
‘Rabbit’ speed.
2. To adjust the speed of the rollers,
press the ‘Rabbit’ for the faster speed
(approximately 1 foot per minute) or
the ‘Turtle’ (approximately 6 inches
per minute) for the slower speed. All
standard pouches and pouch boards
with inkjet paper up to 11 mils thick
should work on the faster speed. For
thicker materials.use the slow ‘Turtle’
speed. The LED light which is on is
the current speed of the PHOENIX.
Heat Control
The Heat of the rollers is controlled in the
HEAT section of the Control Panel. When you
turn the PHOENIX on, the heat will be off and
the rollers cold. The LED Light above the
‘On/Off’ switch will be the color red.
1. To turn the heat on, press the ‘On/Off’
pad once. The LED above the ‘On/Off’
the PHOENIX will automatically be set to
the ‘Pouch’ heat setting and the ‘Pouch’
LED will be lit. The LED above the ‘On/
Off’ switch will be Green indicating the
roller is heating. When that light be-
comes yellow, the PHOENIX is ready to
process your pouch boards.
2. To adjust the heat of the rollers,
press the ‘Pouch’ button when using
pouch boards, mounting boards or flexi-
ble pouches. The ‘Pouch’ heat setting is
the higher setting and has a roll face
temperature of 150° Celsius. The Roll
temperature is a lower 90° Celsius (195°
Fahrenheit) for use with standard inkjet
laminating films.
In case of Emergency: Turn off the main
power switch or unplug the machine
from the power outlet. Open the Roller
Gap Control to its fully open position
and remove your work.
PHOENIX 44 LAMINATOR 9