Demco ML44 manual SET-UP and Electrical Requirements

SET-UP AND ELECTRICAL REQUIREMENTS

The PHOENIX 44 is a professional laminator designed for ease of use. The process speed and temperature have been preset to eliminate operator guesswork. The factory setting will facilitate good quality results using the Flexible Pouches and Pouch Boards using low temperature adhesives.

The PHOENIX 44 can handle Flexible Pouches

and Pouch Boards up to 44 inches (1120mm) wide.

Please familiarize yourself with machine operation before installation, operating the Control Panel and the Nip Control Knob.

Installation of your PHOENIX Laminator Please read and fully understand the entire manual before proceeding to use your laminator.

Without the PHOENIX Stand, your PHOENIX laminator must be lifted and carried to the place where it will be used. This should be done by at least two people, one on each side. Grasp the machine 8-10 inches (20cm-25cm) from the side. It should only be placed on a sturdy, clean, flat, level surface able to support 150 lbs. (70kg). See Stand instructions.

Keep the area around your laminator clear with adequate space around it so you can feed, receive and trim mounted and/or laminated images.

Unpacking your Laminator

1.Open the box, and lift the machine out (at least two persons necessary!). Grasp the machine 8"-10" (200mm-250mm) from either side, at the bottom metal parts. Be careful! The polyethylene bag is slippery!

2.Place the machine on the work area described above.

3.Remove the protective molded foam.

4.Remove the polyethylene bag.

5.Inspect the machine for any physical damage (if damage does exist, report this to the Freight Company on the BILL OF LADING. Contact

Your Dealer to determine if a replacement machine should be shipped to you.

NOTICE! Retain original packaging. Failure to return machines properly packed in original packaging will impose a fifteen percent restocking fee plus costs to repair shipping damage. Contact Technical Service for Return Authorization (see rear cover).

Setting up your Laminator

The PHOENIX laminator should be installed next to a power/main outlet. We do not recommend using an extension cord, but if needed, make sure the cord rating meets or exceeds the machine rating.

The plug and the outlet must be easily accessible. Please ensure that you plug your laminator into a grounded, three-prong outlet. Please ensure that the total load of the other items using the same circuit breaker do not exceed its breaking value.

The US versions of the PHOENIX machines are provided with a fixed power cable and NEMA 5-20 plug.

Use 120Vac 20A grounded outlet only.

110V 20 amp outlet

Using your PHOENIX 44

Plug the power cable into the grounded outlet with appropriate service as described above.

Turn on power with main power switch. Roller will turn continuously while power is on.

Depress the Heat switch and wait approxi- mately 20 minutes for the unit to reach its operating temperature. Also turn the Speed on and set the Control Knob to zero so that the roll heats uniformly. When Ready LED in- dicator is constantly lit, the PHOENIX lamina- tor is ready for use.

CAUTION! Set the Control Knob to the “Open” position when not in use.

NOTE: The laminator may emit vapors the first few times it is used. This is normal and will cease after several minutes of use.

PHOENIX 44 LAMINATOR 5