Denon AVR-1610 Operating the Connected Devices by Remote Control Unit, Registering Preset Codes, Operating Registered Devices

ENGLISH

Operating the Connected Devices by Remote Control Unit

Getting

Registering Preset Codes

DENON and other makes of components can be operated by setting the preset memory.

n Cautions during operation

When registering a preset code, point the remote control transmitter toward the AVR-1610. The status of the registration operation is

Operating Registered Devices

1 Switch to the device to be operated.

TUNER/AMP : To operate a Tuner

iPod

Operating Registered Devices

Operation

mode setting

Connections Started

displayed on the AVR-1610.

1Press the source select button (see below) for the device to be registered

and simultaneously for over 2 seconds.

“RC SETUP START” appears on the display and the remote control unit is set to the preset code registration mode.

: TV	: Digital video recorder
: DVD player	: Video deck
or CD player	Satellite receiver
: Blu-ray disc player	: or cable TV

2 Press ~ and input the 3-digit number of the brand of the component to be preset. The numbers are shown in the Preset Code Table (vEnd of this manual).

When registration is completed, “RC SETUP OK” appears on the display.

bIf the codes could not be registered, “RC SETUP NG” appears on the display. Try again.

3To store the codes of another component in the memory, repeat steps 1 to 2.

bFor details, refer to the component’s operating instructions.

•Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and verify correct operation.

•The preset memory can be set for one component only among the following: DVD/CD and SAT/CBL.

DEVICE : To operate a Blu-ray disc player, DVD player, CD player, Digital video recorder, Video deck,

iPod, Satellite receiver or cable TV MAIN/TV : To operate a TV

2 When “DEVICE” has been selected in step 1, press the source select button for the device to be operated.

The remote control unit is set to the device mode for the device to be operated. When the remote control transmitter is pointed towards the AVR-1610 at this time, the AVR-1610’s input source switches simultaneously.

b The remote control unit stays in the same device mode until a different source select button is pressed.

3 Operate the component.

b For details, refer to the component’s operating instructions.

NOTE

Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed in the list of preset codes.

ON/SOURCE	Power on / Standby z1
1	Play / Pause
2	Stop
3	Pause
MEMORY	MEMORY z1
TOP MENU	Calling out the top menus z1
67	Manual search
	(fast-reverse / fast-forward)
89	Auto search
	(cue)
uiop	Cursor
ENTER	Enter
	Press and	Once
	hold
SEARCH	Browse/Remote	Page search
		mode switching
	mode switching	z2
RETURN	Return
PAGE df	Page up/down z1

z1 : This operation is possible when using a DENON ASD-3N or ASD-3W Control Dock for iPod.

z2 : This operation is possible when using a DENON ASD-1R or ASD-11R Control Dock for iPod.

Specifications Troubleshooting Information Control Remote Playback Settings

4