![](/images/backgrounds/19711/19711-6047x1.png)
ENGLISH
Operating the remote control unit
[MODE SELECTOR 1] | [MODE SELECTOR 2] |
[ZONE2 OFF] | [MAIN ON] |
[NUMBER] |
|
Operating DENON audio components
1 Set [MODE SELECTOR 1] to “AUDIO”.
2 Set [MODE SELECTOR 2] to the position for the component to be operated (CD,
3 Operate the audio component.
For details, refer to the component’s operating instructions.
While this remote control is compatible with a wide range of infrared controlled components, it may be the case that some component models cannot be operated with this remote control.
Setting the preset memory function
•DENON and other makes of components can be operated by setting the preset memory.
•This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the manufacturer of the component as shown in the list
of preset codes ( End of this manual).
•Operation is not possible for some models.
3 Press [ZONE2 OFF] and [MAIN ON] at the same time.
• The indicator starts flashing.
4 Referring to the included list of preset codes, press [NUMBER] to input the preset code (a
5 To store the codes of another component in the memory, repeat steps 1 to 4.
•The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control unit’s transmitting window while setting the preset memory.
•Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed in the list of preset codes.
•Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and verify correct operation.
•The preset memory can be set for one component only among the following:
1 Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.
Set to the AUDIO side for the CD, TAPE or
2 Set [MODE SELECTOR 2] to the component to be registered.
44
ENGLISH