Denon AVR-591 o p, Step, Step, Move, Set up, ENGLISH, the setup, Press AMP, microphone to, 7 press ENTER, 5 press ENTER, Setup over again, and then press ENTER, NOTE, NOTE

ENGLISH

Set up speakers (Audyssey® Auto Setup)

3	Set up	Preparation	Step 1			Step 2
			Speaker Detection			Measurement
	the remote control unit
	nn Set up the operation mode	Connect the setup microphone to the	6	The detected speakers are displayed.		Move	the setup	microphone to
	Press AMP to set the remote control
	unit to amplifier operation mode.	4 SETUP MIC jack of this unit.				8 position 2, use ui to select “Next”,
				Step1:Speaker Detection		and then press ENTER.
						The measurement of		the second position
					MultEQ
				Front Sp.	:Yes	starts. Measurements can be made in up to
				Center Sp.	:Yes
						six positions.
				Subwoofer	:Yes
				Surround Sp.	:Yes
						Step2:Measurement
				Next				MultEQ
						Please place microphone
		When the setup microphone is		Retry		at ear height at
				[ENT]:Next		2nd listening position.
		connected, the following screen is					Next
	Press AMP	displayed.	NOTE
							Cancel
							Calculate
		3-1.Audyssey Auto Setup	If a connected speaker is		not displayed, the	[ENT]:Next
			speaker may not be connected correctly. Check
		MultEQ
		Please place microphone	the speaker connection.
		at ear height at
		main listening position.		Use ui to select “Next” and then		If you want to omit measurements from the next
		Pre Assign:
			7 press ENTER.			position onward, select “Calculate”.
		Normal
		Start				(Go to Step 3 Calculating		)
		Cancel	If “Caution” is displayed:			9 toRepeat6.	step 8, measuring positions 3
		Here, we explain setup using the example of
		[ENT]:Select [RTN]:Back	NOTE
		5.1-channel speaker playback.	Go to “Error messages” (vpage 10), check			When measurement of position 6 is
		For setting other than 5.1-channel surround,	any related items, and perform the necessary			completed, a “All the measurements were
		select “Pre Assign” and perform steps 3 to 4 of	procedures.			finished.” message is displayed.
		“Set up speakers” (vpage 29).	If the problem is resolved,		return and restart	Step2:Measurement
			“Audyssey Auto Setup”.
		Use ui to select “Start” and then						MultEQ
						All the measurements
		5 press ENTER.	When performing Audyssey Auto			were finished.
		When measuring begins, a test tone is	Setup over again				Calculate
		output from each speaker.	Press ui to select “Retry”, and then press				Retry
		• Measuring requires several minutes.					Cancel
			ENTER.			[ENT]:Calculate
		If “Cancel” is selected	When measuring has stopped

“Cancel Auto Setup?” is displayed on the TV screen. If “Yes” is selected, “Audyssey Auto Setup” closes.

qPress ui to select “Cancel”, then press

ENTER.

wPress o p to select “Yes”, then press ENTER.

			Setting up the speakers again
			Repeat the operation from step 4 of Preparation .
8	Remote control operation	Move the cursor	Confirm the setting	Return to previous menu
	buttons	(Up/Down/Left/Right)