Symptom |
| Cause/Solution | Page |
No audio is |
| • Check the connection of the HDMI connectors. | 14 |
output with HDMI | • When outputting HDMI audio from the speakers, set “HDMI | 48 | |
connection. |
| Audio Out” on the menu to “Amp”. |
|
|
| • When outputting HDMI audio from a TV, set “HDMI Audio Out” | 48 |
|
| on the menu to “TV”. |
|
No video is |
| • Check the connection of the HDMI connectors. | 14 |
output with HDMI | • Set the input source to match the connected HDMI connector. | 14, 19 | |
connection. |
| • Check whether the TV is compatible with copyright protection | 14 |
|
| (HDCP). If connected to a device not compatible with HDCP, video |
|
|
| will not be output correctly. |
|
When the following | • Set “HDMI Control” on the menu to “OFF”. To operate power | 30, 48 | |
operations are |
| only for each device, set “Power Off Control” to “OFF”. |
|
performed on |
|
|
|
devices compatible |
|
| |
with HDMI control, |
|
| |
the same operations |
|
| |
occur on this unit. |
|
| |
• Power ON/OFF |
|
| |
• Switching | audio |
|
|
output devices |
|
| |
• Adjust volume |
|
|
|
• Switch input source |
|
| |
| GRadioH |
|
|
|
Symptom |
| Cause/Solution | Page |
|
|
| |
Reception fails, or | • Change the antenna orientation or position. | 18 | |
there is a lot of noise | • Separate the AM loop antenna from the unit. | 18 | |
or distortion. |
| • Use an FM outdoor antenna. | 18 |
|
| • Separate the antenna from other connection cables. | 18 |
| GiPodH |
|
|
|
Symptom |
| Cause/Solution | Page |
|
|
|
|
iPod cannot be |
| • Check the iPod connections. | 18 |
played. |
| • Plug the control dock for iPod’s AC adapter into a power outlet. | – |
|
| • Switch the input source to “DOCK”. | 19 |
“Connection Error” | • Unable to communicate properly. Turn off the power to this unit, | – | |
is displayed. |
| disconnect the iPod and then reconnect it. |
|
“Not Support” is | • The iPod connected to the unit is not compatible. Please make | 21 | |
displayed. |
| sure the iPod you are connecting is compatible. |
|
|
| • The software version of the connected iPod is an old one. Please | – |
|
| update to the latest version. |
|
“Connection Error” | • The iPod is not responding. Turn off the power to this unit, | – | |
is displayed. |
| disconnect the iPod and then reconnect it. |
|
|
|
| ENGLISH | ||
GRemote control unitH |
|
|
|
|
|
|
|
|
|
| |
Symptom | Cause/Solution | Page |
| Simple | |
|
|
|
|
| |
The set cannot be | • Batteries are worn out. Replace with new batteries. |
| 60 |
| |
|
|
| |||
operated with the | • Operate the remote control unit within a distance of about 23 ft / |
| 60 |
| version |
remote control unit. | 7 m from this unit and at an angle of within 30°. |
|
|
| |
|
|
|
| ||
| • Remove any obstacle between this unit and the remote control |
| 60 |
|
|
| unit. |
|
|
|
|
| • Insert the batteries in the proper direction, checking the q and |
| 60 |
|
|
| w marks. |
|
|
|
|
| • The set’s remote control sensor is exposed to strong light (direct |
| 60 |
|
|
| sunlight, inverter type fluorescent bulb light, etc.). Move the set |
|
|
| Basic |
| to a place in which the remote control sensor will not be exposed |
|
|
| |
|
|
|
|
| |
| to strong light. |
|
|
| version |
|
|
|
|
| |
|
|
|
|
|
|
version Advanced
Information
69