Denon AVR-591 1 Install, 2 Connect, FLFR, Speakers, NOTE, Speaker, Circuit”), impedance, Speaker terminals, GViewed from the sideH, When using a banana plug

ENGLISH

1 Install 1 2 3 4 5

2 Connect 1 2 3 4 5

This unit can perform 2.0/2.1 to 7.1-channel surround playback. Here, we explain setup using the example of 5.1-channel speaker playback.

FLFR

SW

C

22 – 30˚

120˚

Speakers

Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being connected to the this unit, and be sure to interconnect the channels and polarities correctly.

Connecting the speaker cables

Peel off about 0.03 ft/10 mm of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.

NOTE

•Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and – sides touch each other (vpage 67 “Protection

Circuit”).

•Never touch the speaker terminals while the power supply is connected. Doing so could result in electric shock.

•Use speakers with the speaker impedances shown below.

Speaker terminals	Speaker
	impedance
FRONT
CENTER	6 – 16 Ω
SURROUND

SL

FL Front speaker (L) FR Front speaker (R)

C	Center speaker
SW	Subwoofer
SL	Surround speaker (L)

SR

Listening position

•Install the surround speakers in a position 2 to 3 ft (60 to 90 cm) higher than ear level.

Surround

When using a banana plug

Tighten the speaker terminal firmly before

SR Surround speaker (R)

Front

speaker

inserting the banana plug.

speaker 2 – 3 ft / 60 – 90 cm

GViewed from the sideH

4 The “Simple version” describes the installation, connection and setup methods for 5.1-channel speakers.

See page 27 for the installation, connection and setup methods for speakers other than 5.1-channel speakers.