Denon AVR-791 Step, NOTE, NOTE, NOTE, Basic, ENTER, ENTER, Simple, RETURN, On the Step, Information, 13press ENTER, 12press ENTER, screen, use ui, Set Dynamic Volume™

ENGLISH

Set up speakers (Audyssey® Auto Setup)

Simple

Step 3

Step 4

Step 5

Finish

Calculating

Check

Store

version

On the Step 2

screen, use ui

Use ui to select the item you want

Use ui to select “Store” and then

Unplug the setup microphone from

10to select “Calculate”, and then press

11to check, and then press ENTER.

13press ENTER.

14the unit’s SETUP MIC jack.

ENTER.

Step4:Check

Save the measuring results.

15

Set Dynamic Volume™.

Basic

Measuring results

are analyzed, and the

MultEQ

Step5:Store

Please check the results

frequency response of each speaker in the

MultEQ

of the measured item.

Please select “Store”

Finish

version

listening room is determined.

to store measurement

Speaker Config.Check

MultEQ

Step3:Calculating

Distance Check

values.

Storing complete.

Channel Level Check

Auto Setup is now

MultEQ

Crossover Freq.Check

Calculating

Store

finished.

Next

Cancel

Please wait...

[ENT]:Select

Turn on Dynamic Volume?

• Subwoofers may measure a greater reported

[ENT]:Store

Yes :

No

distance than the actual distance due to added

[

]:Select [ENT]:Exit

[

-

-

--------]

electrical delay common in subwoofers.

• For details of Dynamic Volume settings, see

• If you want to check another item, press

• Analysis takes several minutes to complete. The

RETURN.

Step5:Store

page 50.

Advanced

MultEQ

nn When turning Dynamic Volume on

time required for this analysis depends on the

Use ui to select “Next” and then

Storing

number of speakers connected.

Please wait...

• Use o to select “Yes”, and then press ENTER.

12press ENTER.

The more connected speakers there are, the

The unit automatically enters “Evening” mode.

longer it takes to perform analysis.

nn When turning Dynamic Volume off

version

• If the result differs from the actual connection

-

NOTE

[

---------]

• Use p to select “No”, and then press ENTER.

status, or if “Caution!” is displayed, see “Error

• Saving the results requires about 10 seconds.

NOTE

messages” (vpage 10). Then carry out Audyssey

• If you do not want to save the measurement

After performing Audyssey Auto

Setup,

do not

Auto Setup again.

results, use ui to select “Cancel”, then select

change the

speaker connections

or subwoofer

• If the result still differs from the actual connection

“Yes” using o p. All the measured Audyssey

volume. In event of a change, perform Audyssey

status after remeasurement or the error message

Auto Setup data will be erased.

Auto Setup again.

still appears, it is possible that the speakers

NOTE

are not connected properly. Turn this unit off,

check the speaker connections and repeat the

During saving of measuring results, be sure not to

measurement process from the beginning.

turn off the power.

• If you change a speaker position or orientation,

perform Audyssey Auto Setup again to obtain

optimal equalizer correction.

Information

Remote control operation	Move the cursor	Confirm the setting	Return to previous menu	9
buttons	(Up/Down/Left/Right)