ENGLISH
Inserting the batteries
Operating range of the remote control
Remote control
Remote control settings (remote control side)
qSlide the rear lid in the direction of the arrow and remove it.
ePut the rear cover back on.
wLoad the two batteries properly as indicated by the marks in the battery compartment.
R6/AA
Point the remote control at the remote sensor when operating it.
30° 
30°
Approx. 23 ft /7 m
Switches when this unit remote control operates another DENON BD players in the vicinity.
Set the remote control code simultaneously on the unit, too (vpage 37 “Remote ID”).
1 Hold POWER ON and OPEN/CLOSE pressed simultaneously.
While these buttons are held pressed, the remote control signal transmission/status display flashes twice, and the remote control enters Setup mode.
2 When the number button “1” is pressed, the remote control ID is set to “DENON 1”.
When the number button “2” is pressed, the remote control ID is
If the battery level is low, the remote control signal transmission/ status display flashes 5 times when a button is pressed.
In this case, replace the batteries soon.
•If the batteries are completely exhausted, the remote control signal transmission/status indicator goes dark.
NOTE
The set may function improperly or the remote control may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.
set to “DENON 2”.
When number key input is completed and the remote control signal transmission/status display flashes twice, the settings for the remote control are completed.
NOTE
•Insert the specified batteries in the remote control.
•Replace the batteries with new ones if the set does not operate even when the remote control is operated close to the unit. (The supplied batteries are only for verifying operation.)
•When inserting the batteries, be sure to do so in the proper direction, following the q and w marks in the battery compartment.
•To prevent damage or leakage of battery fluid:
•Do not use a new battery together with an old one.
•Do not use two different types of batteries.
•Do not attempt to charge dry batteries.
•Do not
•Do not keep the battery in a place exposed to direct sunlight or in places with extremely high temperatures, such as near a heater.
•If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.
•Remove the batteries from the remote control if it will not be in use for long periods.
•Used batteries should be disposed of in accordance with the local regulations regarding battery disposal.
If the signal code of the remote control does not match the signal code of the unit, the remote control code set on the unit is shown on the display.
GExampleH
If the code setting on the unit is “DENON 1”, and the setting on the remote control is “2”, “PLAYER 1” is shown on the display.
NOTE
•If you made the remote control settings incorrectly, the remote control signal transmission/status display flashes for 2 seconds, and then goes off. If this happens, the settings are incorrect and retry the settings.
•Match the signal code of the remote control with the signal code of the unit. If the remote control code is different, you cannot operate the this unit with the remote control.
•Even if you change the remote control code, set the GUI menu
44