ENGLISH

(5) Display

 

 

q

 

 

w

e

 

 

 

r

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

t y u

i o

!0 y !1 !2

iCharacter display

You can select the mode or function using PARAMETERS knob following the short message which is displayed on the character display area.

The character display indicates the operation, mode name, data, etc., and displays such guide messages as “Push/Play” means if

“YES”, push PARAMETERS knob. The display

indicates and marks sometime, note

that mark says you to turn PARAMETERS

knob and marks says to push PARAMETERS knob.

The PARAMETERS LED flashes when you can use PARAMETER knob, otherwise this knob used for Track Selection.

o Play Position indicators

Play position indicator:

The 30 dots indicate a visual track position

4

COMPACT DISCS

1. Precautions on handling compact discs

• Do not allow fingerprints, oil or dust to get on the

 

surface of the disc.

 

If the disc is dirty, wipe it off with a soft dry cloth.

• Do not use benzene, thinner, water, record spray,

 

electrostatic-proof chemicals, or silicone-treated

 

cloths to clean discs.

• Always handle discs carefully to prevent

 

damaging the surface; in particular when

 

removing a disc from its case or returning it.

• Do not bend the disc.

• Do not apply heat.

• Do not enlarge the hole in the center of the disc.

Do not write on the label (printed side) with a

 

hard-tipped implement such as a pencil or ball

 

point pen.

• Condensation will form if a disc is brought into a

 

warm area from a colder one, such as outdoors

 

in winter. Do not attempt to dry the disc with a

 

hair dryer, etc.

qTrack, minute, second and frame displays

These displays indicate current position information.

wTime mode indicators

When the TIME button is pushed, the Time mode indicator switches as follows:

ELAPSED:

Track’s elapsed time is displayed.

REMAIN:

Track’s remaining time is displayed. T. ELAPSED:

The total elapsed time of disc is displayed. T. REMAIN:

The total remaining time of disc is displayed.

yLoop mode indicators

DN-D6000 has Loop mode indicators which consist of A , B and two arrows. A and B marks indicate A and B points have been set.

Two arrows indicate loop setting mode as follows.

or Left arrow only on:

Hot Start mode

Both arrows on:

Seamless Loop mode

, Both arrows flashing:

Seamless Loop Playing

marker during normal play. The 10 Orange

dots indicate the play position during the

reverse play mode.

End of Message:

When the time remaining to the end of the

track is less than the specified time, the EOM

(End Of Message) play position indicator

flashes along with the remaining time,

notifying of the track end.

The EOM time can be set in the presets.

!0KEY ADJ. indicator

KEY ADJ. indicator appears in display when the Key Adjust mode is ON.

!1MEMO indicator

• MEMO indicator appears in display when

2. Precautions on storage

• After playing a disc, always unload it from the

player.

• Always store the disc in the jewel case to protect

from dirt or damage.

• Do not place discs in the following areas:

(1)

Areas exposed to direct sunlight for a

 

considerable time.

(2)

Areas subject to accumulation of dust or high

 

humidity.

(3)

Areas affected by heat from indoor heaters,

 

etc.

ePlay mode indicators

When SINGLE indicator lights up, playback will finish at end of current track.

When CONT. indicator lights up, playback continues.

rBPM indicators

Lights when the BPM is displayed on the pitch display.

tMP3 indicators

• Lights when an MP3 disc is detected.

, Left arrow on, right flashing:

Exit play from Seamless Loop

uMP3 file search mode indicator

FILE:

FILE indicator appears in display, when in the FILE name search mode.

FOLDER:

FOLDER indicator appears in display, when in the FILE & FOLDER name search mode.

TITLE:

TITLE indicator appears in display, when in the TITLE name search mode.

ARTIST:

ARTIST indicator appears in display, when in the ARTIST name search mode.

there is a memo setting found for the current

playing track or the track at which the Cue

standby mode is currently set.

!2Pitch display

This indicator display the playback speed (pitch).

10