Denon DN-M991R operating instructions Instantaneous play Hot Start, Hot Start Load

(3) Instantaneous play (Hot Start)

Preset up to 10 tracks using the parallel remote, the serial remote or a key board (PS/2 connector, US keyboard with 101 or 104 keys recomended) to enable instantaneous play of the desired tracks. This function is called instantaneous play (Hot Start).

•When parallel remote is to be used, a control circuit for instantaneous play (Hot Start) is required. For information about the control circuit, contact your store of purchase.

•When serial remote is to be used, contact your store of purchase.

NOTE:

The hot start data is cleared if the editing or recording operations are performed during the hot start mode.

ENGLISH

NOTES:

•The instantaneous play (Hot Start) mode will end with one track.

•A press of a number button during the instantaneous play (Hot Start) mode will cause the unit to switch to the track of the pressed number and start playing.

•Cue detection is also performed at the time of instantaneous play (Hot Start) loading.

Tracks with a setting level less than 10 seconds from the beginning of the track are loaded from the beginning of the track.

Even when the level of cue detection is changed after loading, the pause position will not change until the initial data is cleared.

Hot Start Load

Data loading.

1Set the cartridge and cue or pause at the track for hot start playback.

10 TRACK LOAD.

Press the the LOAD button.

•The data for ten tracks starting from the track at which the cue or pause mode is set is loaded into the hot start RAM.

	(Example: Track 4 is set to pause)
2-1	Disc

Instantaneous play

(Hot Start)

•When the data loading is completed, the STANDBY/CUE button will light and the unit will be set to instantaneous play (Hot Start) standby.

NOTE: When the stop operation is set during data loading and the data loading number (from 1 to 10) is completed, data loading of subsequent tracks is stopped.

1 TRACK LOAD.

While depressing the LOAD button, press the number button (from 1 to 10) for which data is to be entered.

2-2

•When data loading is completed, the CUE LED lights steadily.

PROGRAM TRACK LOAD.

•Hot start data can also be loaded in the programmed

2-3play mode. The data is loaded in the programmed order. The programmed play mode is canceled after the data is loaded.

Hot Start

Starting the play operation.

During instantaneous play (Hot Start) standby, press the number button (from 1 to 10) that is to be played to start the instantaneous play (Hot Start) operation.

1

The number of the button for the track at which playback started is shown on the display.

•The PLAY/PAUSE button flashes when an EOM is detected during playback (when the EOM is turned on with the presetting).

•When play finishes, the unit returns to instantaneous play (Hot Start) standby.

Stopping the play operation.

A press the STOP button during the play

2operation causes the play to stop and returns the unit to instantaneous play (Hot Start) standby.

Repeat play.

When the REPEAT button is pressed, the repeat mode is set.

Press the number button of the track to be played (from 1 to 10) to repeatedly play that track.

3• Press the REPEAT button while a track

is being played to repeatedly play that	REPEAT
track.

•Press the REPEAT another time to cancel the repeat play mode.

Set the standby mode and press the MODE button on the main unit twice to cancel the hot start mode.

•	The hot start mode is canceled and the	MODE
4	edit mode is set.

25