Desa Glass Panel Removal, Louvers, For Models CD32M and CD36M Series, For Model CD42M

GLASS PANEL REMOVAL

Before proceeding, make sure gas control valve is in the “OFF” position.

1.To remove louvers, pull both spring latches (located in each end of louver) towards center of appliance simultaneously until disengaged from locating holes. Repeat for bottom end spring latches and pull louver outward (see figure 17).

Figure 17 LOUVERS

FOR MODELS CD32M AND CD36M SERIES

•Place log #1 (back log) on top of grate. Make sure the notches in the bottom of the log fit over the grate.

•Rest log #2 (large front log) on the pins on the front part of the grate.

•Place log #3 (C-shaped crossover log) onto the rear and front logs. Make sure it is seated properly on the smooth surface on the front log and on the pin on the back log as shown below.

•Place log #4 (small, round log) on the pin on the right side of front log as shown below.

•Place log #5 (small log) onto the front left part of the grate making sure the notches fits over the prongs of the grate.

•Place log #6 onto two pins on the left side of back and front log.

2.Remove screen rod by removing rod loop from glass door center bracket. Then slide the screen rod either to the left or right of the fireplace until one of the rod ends is free to completely remove the screen from the fireplace.

3.To open the glass door, undo the latches located on the top and bottom side of the firebox (see figure 18). Carefully swing the door to the left. The glass is securely mounted to the firebox by means of five screws.

Figure 18 SPRING LATCHES

•Place lava rock along sides and front of firebox bottom in areas that are visible. It is not necessary to use all of the lava rock provided.

FOR MODEL CD42M

•Place log #1 (base log) onto pin on left side of grate.

•Rest left side of log #2 (front log) onto top of log #1. Place right side of log onto second pin located on the right side of the grate.

Place log #3 (rear log) onto pins on rear of grate.

•Place log #4 (crossover log) onto pins from both logs #2 and #3.

•Place log #5 (top log) onto right pin of front log (#2) and the smooth surface of rear log (#3). Make sure it is seated properly.

LOG INSTALLATION

Each log is marked with a number in the following diagrams. These numbers will help in identifying the logs when installed. It is very important to install these logs exactly as instructed. Do not modify logs and only use logs supplied with fireplace.

- 9 -

For more information, visit www.desatech.com