•Install the identification label enclosed with the gas valve regulator to the valve body where it can easily be seen (see figure 23).
Figure 23 GAS CONTROL VALVE CONVERSION |
WARNING: The conversion kit must be installed by a qualified service technician in accordance with the manufacturers instructions and all applicable codes and requirements of the authority having jurisdiction. If any information in these instructions is not followed correctly, a fire, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service technician is responsible for the proper installation of this conversion kit.
WARNING: Never use an open flame to check for a leak. Apply commercial leak test solution to all gas joints. Bubbles forming show a leak. Correct all leaks at once.
WARNING: Test all gas piping and connections for leaks after installing or servicing. Correct leaks at once.
FACE EXTENSION (FOR MODEL CD32M ONLY)
Model CD32M comes equipped with a front face extension. The front face extension would add 3- ½” to the width and ¾” to the height of the fireplace face.
To install the face extension:
•Remove the existing screws from front face assembly as shown in figure 24.
•Align holes on top face extension (figure A) with holes on the top side of the front face assembly and secure with screws previously removed (follow this step to install left and right face extension).
•Secure top face extension with left and right face extensions with two sheet metal screws (figure B).
FIGURE A |
FIGURE B |
Figure 24 FRONT FACE EXTENSION |
- 13 - | For more information, visit www.desatech.com |
