Manuals / Desa / Household Appliance / Electric Heater

Desa LSL3124P, CDL3924NT, CDL3924PT Specifications, Echo Valley Oak Log, Meadowbrook Oak Log

Models: LSL3124P CDL3924PT CDL3924NT

1 32

Download 32 pages 9.88 Kb

Page 26

SPECIFICATIONS

OPTIONAL POSITIONING OF THERMOSTAT SENSING BULB Continued

4.The mounting clip must be a minimum of 3" from bottom of ﬁreplace to prevent crimping of capil- lary. Once you have decided on a location, clean the area thoroughly. Remove the paper backing from the adhesive on back of mounting clip. Press the clip into the new location so that the thermostat sensing bulb will be positioned vertically with the capillary at the bottom (see Figure 37). Slide the thermostat sensing bulb into the clip.

IMPORTANT: Do not crimp capillary.

Thermostat

Sensing Bulb

Adhesive- backed

Do Not Crimp Mounting Clip Capillary

Capillary

Figure 37 - Positioning the Thermostat Sensing Bulb in the Vertical Position with the Capillary at the Bottom

	SPECIFICATIONS
	Echo Valley Oak Log
	Variable Manually-Controlled
Btu (Variable)	16,000/31,500
Type Gas	Propane/LP - Natural
Ignition	Piezo
Manifold Pressure	8.0" W.C. - 3.5" W.C.
Inlet Gas Pressure (in. of water)
Maximum	14" - 10.5"
Minimum*	11" - 5"
Shipping Weight	38 lbs.
* For purpose of input adjustment
	Meadowbrook Oak Log
	Thermostatically-Controlled
Btu (Variable)	26,000/39,000
Type Gas	Propane/LP - Natural
Ignition	Piezo
Manifold Pressure	8.0" W.C. - 3.5" W.C.
Inlet Gas Pressure (in. of water)
Maximum	14" - 10.5"
Minimum*	11" - 5"
Shipping Weight	28 lbs.
* For purpose of input adjustment

26

www.desatech.com

111347-01E

Image 26

Desa LSL3124P, CDL3924NT, CDL3924PT installation manual Specifications, Echo Valley Oak Log, Meadowbrook Oak Log

Contents

WHAT TO DO IF YOU SMELL GAS TABLE OF CONTENTS SAFETY INFORMATION LOCAL CODES SAFETY INFORMATIONState of Massachusetts The installa UNPACKINGOPERATION SAFETY DEVICEAIR FOR COMBUSTION AND VENTILATION PIEZO IGNITION SYSTEMDETERMINING FRESH-AIRFLOW FOR HEATER LOCATION AIR FOR COMBUSTION AND VENTILATIONContinued VENTILATION AIR FROM OUTDOORS ContinuedVENTILATION AIR See Ventilation Air From Inside BuildingINSTALLATION Continued MINIMUM FIREPLACE CLEARANCE TOWhen Using Hood Accessories, pageWithout Using Hood ContinuedFLOOR CLEARANCES If Installed at Floor LevelContinued Figure 9 - Minimum Fireplace ClearancesINSTALLING HEATER BASE ASSEMBLY Installation Items NeededCONNECTING TO GAS SUPPLY PROPANE/LP PRESSURE TESTING GAS SUPPLY PIPING SYSTEMCHECKING GAS CONNECTIONS NATURALWith the heater set to HI, check INSTALLING LOGSContinued to see if ﬂames contact any log. IfREAD BEFORE LIGHTING MANUALLY-CONTROLLEDMODELS FOR YOUR SAFETYContinued Figure 19 - Left and Right Front LogContinued LIGHTING INSTRUCTIONSVARIABLE CONTROL OPERATION MANUAL LIGHTING PROCEDURETHERMOSTAT MODELS FOR YOUR SAFETY READ TO TURN OFF GAS TO APPLIANCEFigure 25 - Control Knob and Ignitor 2.Make sure equipment shutoff valve is fully open3.Turn control knob clockwise to the OFF position Button LocationContinued MANUAL LIGHTING PROCEDUREsee Troubleshooting, page TO TURN OFF GAS TO APPLIANCELOGS CLEANING AND MAINTENANCEBURNER INJECTOR HOLDER AND PILOT AIR INLET HOLE POSSIBLE CAUSE TROUBLESHOOTINGOBSERVED PROBLEM REMEDYContinued OBSERVED PROBLEMsee Cleaning and Mainte POSSIBLE CAUSEWARNING If you smell gas Shut off gas supply Figure 31- Adhesive-backedMounting Clip Assembly and Thermostat Sensing BulbFor Masonry and Factory-BuiltMetal Fireplace Figure 32 - Location of Gas ValveMeadowbrook Oak Log SPECIFICATIONSEcho Valley Oak Log PARTS NOT UNDER WARRANTY CLEANING KIT - GCK Not ShownPARTS UNDER WARRANTY EQUIPMENT SHUTOFF VALVE GA50103 - ODS Pilot ILLUSTRATED PARTS BREAKDOWN3 - ODS Pilot Propane/LPPARTS LIST 111347-01E THERMOSTATICALLY- CONTROLLED MEADOWBROOK OAK LOG LIMITED WARRANTY VENT-FREEGAS LOG HEATERS WARRANTY INFORMATIONKEEP THIS WARRANTY