Installation
Continued
4.Install remote receiver unit onto gas log heater base using phillips head screws (see Figure 19).
5.Connect wires as shown in Figure 20.
Front
Screws
Receiver |
|
| |
Battery | Terminal | ||
Wires | |||
Battery | |||
Clip |
| ||
|
|
Figure 21 - Installing Receiver on the
Back of the Base
Back
Remote
Receiver
Figure 19 - Installing Remote Receiver
White Wire From Receiver
Red Wire | Valve |
From | |
Receiver |
|
Figure 20 - Connecting Wires
INSTALLING WIRELESS hand- Held REMOTE control
ACCESSORY
Two
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner of heater.
2. Locate the battery clip mounted on the back of the receiver.
3. Slide a
4. Attach the terminal wires to the battery.
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to the battery. Place battery into the battery housing.
3. Replace battery cover onto remote control unit.
Battery
Cover
Terminal
Wires
Battery
Battery
Figure 22 - Installing Battery in Hand-
Held Remote Control Unit
16 | www.desatech.com |