Operating heater
Continued
MANUAL LIGHTING
PROCEDURE
1.Follow steps 1 through 6 under Lighting Instructions, page 19.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11 under Lighting Instructions, page 20.
optional Hand-Held
REMOTE OPERATION
Note: HRC201
NOTICE: You must light the pilot before using the
After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 33). Note: The burner may light if
IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.
Flame Adjustment | Control | ||
Knob |
| ||
| Knob | ||
|
| ||
ON | IH |
| PILOT |
| F | F | |
OFF |
| O | O |
|
| N | |
REMOTE | LO |
|
|
|
|
|
Selector Switch in Remote Position
Figure 33 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
On/Off Series (Model HRC101)
Hold the control button on the
To Lock press both buttons on
To Unlock press both buttons together on
Indicator | Control | |
Light | ||
Button | ||
|
Figure 34 - On/Off Hand-Held Remote
Control Unit (HRC101)
Thermostat Series (Model
HRC201)
The
|
|
|
| Digital |
|
|
|
| Display |
Locks |
| AUTO | Shows | |
ROOM |
| SET | Temperature | |
TEMP |
| TEMP | ||
System to |
|
|
| and Settings |
Prevent | LOCK | TEMP | POWER | Turns Hand- |
Accidental |
|
|
| |
|
|
| Held Remote | |
Ignition |
|
|
| |
|
|
| On or Off and | |
| MANU | ºC/ºF | AUTO | |
|
|
|
| Allows You |
Turns |
|
|
| to Choose |
|
|
| the Manual | |
Burners |
|
|
| Setting |
On or Off |
|
|
| Selects AUTO |
|
|
|
| |
Increases or |
|
|
| Mode |
|
|
|
| |
Decreases Room | °C/°F Mode | |||
Temperature in |
|
|
|
|
AUTO Mode | Button |
|
Figure 35 - Thermostat
www.desatech.com | 21 |