Installation
Continued
INSTALLING LOGS
WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: After installa- tion and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to Hi, check to see if flames contact any log. If so, reposition logs according to the log installation instructions in this manual. Flames contact- ing logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place the front log (#1) on the grate fingers. Make sure the front log rests firmly between the grate fingers and the grate base (see Figure 23).
2.Place the base of the middle log (#2) in the
3.Locate pegs on the bottom of back log (#3). Slide these pegs into the holes in the grate base behind the burner (see Figure 25).
4.Locate pegs on the bottom of crossover log (#4). Slide these pegs into the holes located in middle log (#2) and back log (#3). See Figure 26, page 18, for placement.
Front Log (#1)
Grate
Fingers
Grate
Base
Figure 23 - Installing Front Log (#1)
(CCL3930PR/NR Shown)
Middle Log (#2)
| Burner |
Tab | |
| |
| Slot |
Figure 24 - Installing Middle Log (#2)
(CCL3930PR/NR Shown)
Pegs
Hole in
Grate
Base
Burner
Figure 25 - Installing Rear Log (#3)
(CCL3930PR/NR Shown)
www.desatech.com | 17 |