Desa RL2718PA/NA, CRL3124PA/NA, CCL3018PA/NA WARNING If you smell gas Shut off gas supply

TROUBLESHOOTING

Continued

WARNING: If you smell gas

•Shut off gas supply.

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Fol- low the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

IMPORTANT: Operating heater where impurities in air exist may create odors. Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes. These fumes may mix with combustion air and create odors. These odors will disappear over time.

OBSERVED PROBLEM	POSSIBLE CAUSE		REMEDY
Heater produces unwanted	1.	Heater burning vapors from	1.	Open window and ventilate
odors		paint, hair spray, glues, clean-		room. Stop using odor caus-
		ers, chemicals, new carpet,		ing products while heater is
		etc. (See IMPORTANT state-	2.	running
	2.	ment above)		Locate and correct all leaks
		Gas leak. See Warning		(see Checking Gas Connec-
		statement above		tions, page 14)
Heater shuts off in use	1.	Not enough fresh air is avail-	1.	Open window and/or door for
(ODS operates) temperature	2.	able	2.	ventilation
drops to a lower than ideal level		Low line pressure		Contact local propane/LP or
before log set comes back on	3.	ODS/pilot is partially	3.	natural gas company
				Clean ODS/pilot (see Cleaning
		clogged		and Maintenance, page 23)
Gas odor even when control	1.	Gas leak. See Warning	1.	Locate and correct all leaks
knob is in OFF position		statement above		(see Checking Gas Connec-
	2.	Control valve defective	2.	tions, page 14)
				Replace control valve
Gas odor during combustion	1.	Foreign matter between con-	1.	Take apart gas tubing and
	2.	trol valve and burner	2.	remove foreign matter
		Gas leak. See Warning		Locate and correct all leaks
		statement above		(see Checking Gas Connec-
				tions, page 14)
Logs set cycles to pilot, but	1.	Thermostat sensing bulb needs	1.	Reposition thermostat sensing
room		to be repositioned		bulb (see Optional Positioning
				of Thermostat Sensing Bulb,
				beginning on page 28

113097-01E www.desatech.com 27