INSTALLATION
Continued
Single Burner Seasonal Oak Models CRL2718PA/NA, CRL3124PA/NA
WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
The Seasonal Oak Log Set is a reversible log set. This means that the two bottom logs may be turned to face either direction. The top logs, however, must remain in the same position. Do not modify logs. Only use logs supplied with heater.
1.Place the back log onto the back of the base as- sembly. Make sure log sits forward against the two posts in front of log (see Figure 27). This log may be turned to face either direction.
2.Place front log onto grate on front of base as- sembly. The log will fit down between grate fingers and posts on front of base assembly (see Figure 28). This log may be turned to face either direction.
3.Place the left and right crossover logs on top of the back log and front log. Make sure pins on front and back are inserted into holes on crossover logs (see Figure 29). Crossover logs must be placed as shown in Figure 29 or the holes will not seat onto the pins.
4.Add lava rock around base of heater if desired. Do not put lava rock on logs or burner.
Back Log
Post
Base
Assembly
Post
Figure 27 - Installing Back Log
Front Log
Post
Grate 
Fingers Base 
Post
Assembly
Figure 28 - Installing Front Log
Left Crossover Log
Right
Crossover Log
Figure 29 - Installing Left and Right
Crossover Logs
18 | www.desatech.com |
