INSTALLATION | OPTIONAL WALL MOUNTED |
Continued | THERMOSTAT - GWMT1 |
| Remote Receiver | |
| Red Wire | |
Black Wire |
| |
Wire Harness* |
| |
Wires from | Red | |
Valve | ||
Wire | ||
|
Black
Wire
Figure 29 - Installing Remote Receiver
*Wire harness provided in the fireplace hard- ware pack.
Installing 9-Volt Battery in Hand-Held Remote Control Unit
1.Remove battery cover on back of remote con- trol unit.
2.Attach terminal wires to the battery (not in- cluded). Place battery into the battery housing.
3.Replace battery cover onto remote control unit.
Terminal | Battery Cover |
| |
Wires |
|
| |
Battery |
|
| Remote |
| Control |
| Battery Unit |
| Housing |
Figure 30 - Installing Battery in Hand-Held
Remote Control Unit (GHRCB Series)
Terminal
9-Volt Wires
Battery
WARNING: Read and follow installation instructions. Instal- lation should be done by a quali- fied installer familiar with low- voltage wiring procedures.
WARNING: Do not connect this thermostat to any electrical source! Electrical shock and/or fire hazard will occur.
1.Connect one terminal of 25 ft. wire to bottom contact of switch (see Figure 32).
2.Connect remaining wire terminal to the “TH” terminal on the control valve. Make sure that wire terminals are in the positions on your unit as pictured in Figure 32. If wires are not “crossed” the thermostat will not work.
3.Route the 25 ft. wire to a convenient location to mount your thermostat (no outside wall). IMPORTANT: The wire may be shortened but must not be lengthened.
The thermostat should be mounted 54" above the floor in a location where there is good air circulation. Avoid heat sources such as lamps, direct sunlight, fireplace, or heat and air con- ditioning ducts.
4.Gently remove the cover of the thermostat from the base. Grasp the sides of the cover firmly and pull to separate from the base.
5.Feed the electrical wires through the rectan- gular slots on each side of the base (see Fig- ure 33, page 22).
WARNING: Do not connect the thermostat to a power source. Electrical shock and/or a fire hazard will occur.
Switch on Gas | Control | |
Fireplace | ||
Valve | ||
|
| Remote | AUTO |
| |
| Control | OFF |
| |
| ON |
| ||
Battery | Unit | One terminal |
| |
Housing | Battery Cover | To Wall Thermostat | ||
| of 25 ft. wire | |||
Figure 321- Installing Battery in |
| or Switch | ||
Figure 32 - Connecting Wire Terminals | ||||
Remote Control Unit (GHRCTB Series) | ||||
20 | www.desatech.com |
