Desa EFS26PRA Optional Remote Control Accessories, Local Codes, Product Features, Unpacking

OPTIONAL REMOTE

CONTROL ACCESSORIES

There are four optional remote controls that can be purchased separately:

•wall switch

•hand-held ON/OFF remote

•wall thermostat

•hand-held thermostat remote See Accessories, pages 36 and 37.

LOCAL CODES

Install and use fireplace with care. Follow all lo- cal codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

PRODUCT FEATURES

SAFETY PILOT

This fireplace has a pilot with an Oxygen Deple- tion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent-free room fireplaces. The ODS/pilot shuts off the fireplace if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This fireplace has a piezo ignitor. This system re- quires no matches, batteries, or other sources to light fireplace.

UNPACKING

1.Remove fireplace and hood from carton. Log is wrapped and inside fireplace. Do not re- move at this time.

2.Remove all protective packaging applied to fireplace for shipment.

3.Make sure your fireplace includes one hard- ware packet.

4.Check fireplace for any shipping damage. If fireplace is damaged, promptly inform dealer where you bought fireplace.

ASSEMBLY

WARNING: Always have branch support and screen in place before operating fireplace. This prevents excessive tem- peratures on fireplace surfaces.

WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury.

ASSEMBLING FIREPLACE

Tools Required:

•Phillips screwdriver

•5/16" hex wrench

•slotted screwdriver

•scissors

1.Remove two screws that hold fireplace screen in place for shipping. These screws are located near top of screen. Discard screws. Lift fireplace screen up and pull out to remove. Set screen aside until installation has been completed.

2.Cut two plastic straps to remove the log from the firebox cavity.

3.An optional blower is available. See Acces- sories, pages 36 and 37. Install optional blower now. Follow installation instructions provided with blower or (see page 14).

Shoulder

Screw

Burner Support

With Log

Locator Tabs

Screen

Branch

Support

Figure 2 - Removing Screen

113110-01A www.desatech.com 5