Desa VMH26NRB, EFS26NRA Cleaning And Maintenance, Wiring Diagram, Continued, Log Set, Cabinet

CLEANING AND

MAINTENANCE

Continued

3.Blow air through the ports/slots and holes in the burner.

4.Check the injector holder located at the end of the burner tube again. Remove any large particles of dust, dirt, lint, or pet hair with a soft cloth or vacuum cleaner nozzle.

5.Blow air into the primary air holes on the in- jector holder.

6.In case any large clumps of dust have now been pushed into the burner repeat steps 3 and 4.

Clean the pilot assembly also. A yellow tip on the pilot flame indicates dust and dirt in the pilot as- sembly. There is a small pilot air inlet hole about two inches from where the pilot flame comes out of the pilot assembly (see Figures 48 or 49 depend-

LOG SET

•If you remove one-piece log set for cleaning, refer to Installing Log Set and Screen, page 21, for placement instructions.

•Replace log set if broken or chipped (dime-sized or larger).

CABINET

Air Passageways

•Use a vacuum cleaner or pressurized air to clean.

Exterior

•Use a soft cloth dampened with a mild soap and water mixture. Wipe the cabinet to remove dust.

WIRING DIAGRAM

ing on model). With the unit off, lightly blow air through the air inlet hole. You may blow through a drinking straw if compressed air is not available.

Injector Holder

Ports/Slots

Burner Tube

Primary Air

Inlet Holes

Figure 47 - Injector Holder On Outlet

Burner Tube

Pilot Air Inlet Hole

Pilot Assembly

Figure 48 - Pilot Inlet Air Hole

(Propane/LP Gas)

Pilot Air

Inlet Hole

Pilot Assembly

Figure 49 - Pilot Inlet Air Hole

(Natural Gas)

Auto
	Off	Switch
	On
	Thermopile

Black

Red

TPTH TH

Gas Control

TPTH TP

Red

White

113110-01A www.desatech.com 27