Cleaning and Maintenance
Continued
Replacing log
1.Follow steps 1 through 4 of Cleaning Firebox, page 8.
2.Remove screws from each side of log that secure log to sides and remove log (see Figure 10).
3.Install new log using screws removed in step 2.
4.Replace front glass and brackets.
5.Replace trim.
Screw
Ember LED
Strip with
Standoffs
Log
Figure 10 - Removing Log and Ember
LED
Replacing Ember Strip
1.Follow steps 1 and 2 under Replacing Log.
2.Locate ember LED strip (see Figure 10). Disconnect wire (right side).
3.Remove ember LED strip by squeezing top of standoffs and discard.
4.Connect new ember LED strip using exist- ing standoffs.
5.Reconnect wire to LED strip.
6.Follow steps 3 through 5 under Replac- ing Log.
Replacing Heater/Blower
1.Follow steps 1 and 4 of Cleaning Firebox, page 8.
2.Remove screws from around top panel of firebox (see Figure 11).
3.There are several wires attached to the top panel. Carefully lift top panel.
4.Disconnect heater/blower wires from main circuit board.
5.Remove screws holding heater/blower to top panel (see Figure 11).
6.Remove brackets from heater/blower (see Figure 12). Save brackets and screws.
7.To remove heater from blower, remove 4 screws (2 per side).
8.If replacing blower, remove screws from brackets on blower (see Figure 13, page 10). Install brackets to new blower.
9.Replace blower or heater. Replace screws removed in step 7.
10.Hold heater/blower with brackets in place against top panel and replace screws removed in step 5.
11.Reconnect wires to main circuit board (see Wiring Diagram, page 14).
12.Replace glass with brackets, and top panel.
13.Replace trim.
Top Panel Screws | Screws Securing |
| |
| Heater/Blower |
Figure 11 - Removing Top Panel and
Heater/Blower
Brackets
Figure 12 - Removing Brackets from
Heater/Blower