Desa FPVF33PR installation manual Connecting Fireplace To Gas Supply, Installing, Continued

INSTALLING

Continued

A.G.A. Design-Certified Manual Shutoff Valve

With 1/8" NPT Tap*

Approved

Flexible

Gas Line

		From Gas Meter
3" Minimum	(5" W.C. to 10.5" W.C.
		Pressure)
			Sediment
		Tee Joint	Trap
		Pipe Nipple
Figure 17 - Gas Connection		Cap

*Purchase the optional A.G.A. design-certified manual shutoff valve from your dealer. See Accessories, page 34.

CONNECTING FIREPLACE TO GAS SUPPLY

Installation Items Needed

•5/16" hex socket wrench or nut-driver

•Phillips screwdriver

•sealant (resistant to propane/LP gas, not provided)

1.Remove fireplace screen. Remove two screws that hold fireplace screen in place for shipping. These screws are located near top of screen. Discard screws. Lift fireplace screen up and pull out to remove.

2.Remove access door from rear or side of fireplace. See Product Identification, page 4, for access door locations.

3.Remove screws that attach log base assembly to fireplace (see Figure 18).

Carefully lift up log base assembly and remove from fireplace (see Figure 18). Note: If adding the G8000 brick liner accessory, install it now. Follow instructions in G8000 accessory kit.

CAUTION

Do not pick up log base assembly by burners. This could damage burners. Only handle base by grates.

Continued

Figure 18 - Removing Log Base Assembly From Fireplace 17

103280