OPERATING | 6. Continue pressing control knob in. Press and release ignitor button. This will light | |
| ||
FIREPLACE | pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor | |
button until pilot lights. |
| |
Thermostat- | Note: If pilot does not stay lit, contact a qualified service person or gas supplier | |
for repairs. Until repairs are made, light pilot with match. To light pilot with | ||
Controlled Models | match, see Manual Lighting Procedure, below. |
|
Continued | 7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, | |
| release control knob. |
|
| Note: If pilot goes out, repeat steps 3 through 7. This fireplace has a safety | |
| interlock system. Wait one (1) minute for system to reset before lighting pilot | |
| again. |
|
| • If control knob does not pop out when released, contact a qualified service | |
| person or gas supplier for repairs. |
|
| Thermocouple | Ignitor Electrode |
|
| Pilot Burner |
Figure 29 - Pilot
8. Turn control knob counterclockwise to desired heating level. The burners should light. Set control knob to any heat level between HI and LO.
CAUTION
Do not try to adjust heating levels by using the manual shutoff valve.
TO TURN OFF GAS TO APPLIANCE
Shutting Off FireplaceTurn control knob clockwise Clockwise to the OFF position.
Shutting Off Burners Only (pilot stays lit)Turn control knob clockwise Clockwise to the PILOT position.
THERMOSTAT CONTROL OPERATION
You can set the thermostat control knob to any comfort level between HI and LO. The thermostat will gradually modulate the heat output and flame height from higher to lower settings, or pilot, in order to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amount of space to be heated, the output of the central heating system, etc.
Note: Selecting the HI setting will cause the burner to remain on without modulating down in most cases.
MANUAL LIGHTING PROCEDURE
1.Follow steps 1 through 5 under Lighting Instructions, page 22.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow step 8, above.
Continued 23
103280