Desa FPVF33PR Variable Control Operation, Manually-Controlled, Models, Operating, Fireplace

C-clockwise

OPERATING	6. Continue pressing control knob in. Press and release ignitor button. This will light
FIREPLACE	pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor
	button until pilot lights.
Manually-Controlled	Note: If pilot does not stay lit, contact a qualified service person or gas supplier
	for repairs. Until repairs are made, light pilot with match. To light pilot with
Models	match, see Manual Lighting Procedure, below.
Continued	7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds,
	release control knob.
	Note: If pilot goes out, repeat steps 3 through 7.
	• If control knob does not pop out when released, contact a qualified service
	person or gas supplier for repairs.
	Ignitor Electrode
	Thermocouple	Pilot Burner

Figure 31 - Pilot

8. Slightly depress and turn control knob counterclockwise to the HIGH position. Both burners should light. Set control knob to either HIGH or LOW.

VARIABLE CONTROL OPERATION

The variable control valve can be set to any heat setting and flame height desired, by simply turning the control knob until that setting is attained. Even the lowest setting provides realistic flames and glowing embers from two burners. Selecting higher settings produces greater heat output. This results in increased heating comfort.

WARNING

WARNING ICON G 001

Do not operate heater between locked positions.

CAUTION

WARNING ICON G 001

Do not try to adjust heating levels by using the manual shutoff valve.

TO TURN OFF GAS TO APPLIANCE

Shutting Off Fireplace
1.	Turn control knob clockwise	Clockwise to the HIGH position.
2.	Slightly depress control knob and turn clockwise		Clockwise to the PILOT position.
3.	Slightly depress control knob and turn clockwise		Clockwise to the OFF position.
Shutting Off Burners Only (pilot stays lit)
1.	Turn control knob clockwise	Clockwise to the HIGH position.
2.	Press in and turn clockwise	Clockwise to the PILOT position.

MANUAL LIGHTING PROCEDURE

1. Follow steps 1 through 5 under Lighting Instructions, page 24.

2. Depress control knob and light pilot with match.

3. Keep control knob pressed in for 30 seconds after lighting pilot. After 30

seconds, release control knob. Now follow step 8, above.

103280

Continued 25